聚合物驱剖面返转数值模拟方法研究.pdf

Journal of Oil and Gas Technology 石油天然气学报, 2016, 1(1), 55-61 Published Online March 2016 in Hans. /journal/jogt /10.12677/jogt.2016.11008 Research on Numerical Simulation Method of Section Inversion during Polymer Flooding Ailing Zheng1, Xiaodong Kang2, Dehua Liu1 1College of Petroleum Engineering, Yangtze University, Wuhan Hubei 2CNOOC Research Center, Beijing Received: Dec. 7th, 2015; accepted: Jan. 17th, 2016; published: Mar. 15th, 2016 Copyright ? 2016 by authors, Yangtze University and Hans Publishers Inc. This work is licensed under the Creative Commons Attribution International License (CC BY). /licenses/by/4.0/ Abstract The inversion of injection profile was easily induced in single slug injection in heterogeneous re- servoirs; it was unfavorable for enhancing oil recovery. In allusion to the problems of high cost, long duration and heavy workload of laboratory simulation, which were hard to be described by conventional reservoir simulation, based on percolation theory and physical-chemical property in polymer flooding, an uncross flow linear percolation model of two parallel layers was established. Compared with the characteristics of simulation software, a simulation method for profile inver- sion was proposed based on the sorting of reservoir physical property. The studied method is used for systematically studying the factors influencing the profile inversion; the result shows that the permeability contrast, its injection time and its concentration are the major factors affecting the inversion; it provides a technical support for studying the regulation and the reduction of pro- file inversion in