经济师考试中级运输公路考前模拟试卷.doc

声明：本资料由 大家论坛经济师考试专区 HYPERLINK /forum-186-1.html /forum-186-1.html 收集整理，转载请注明出自  HYPERLINK  更多经济师考试信息，考试真题，模拟题： HYPERLINK /forum-186-1.html /forum-186-1.html 大家论坛，全免费公益性经济师论坛，等待您的光临！  PAGE 32 /  NUMPAGES 33 大家网 TopS TopS 大家网  PAGE 33 /  NUMPAGES 33 or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part plant product quality certificate for each variable spring supports, constant support hangers, dampers, damper function, there should be factory calibrated test and performance test copies of the record. If necessary, review should be更多精品在大家！  HYPERLINK  大家学习网 or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the weldi