FANUC机器人的培训资料.ppt

When to Use何时使用: High Voltages 高电压 ( 23V To 33V ) Two Amperages Levels- Peak and Background 两种电流-峰值和基值电流 ( 200A To 500A ) Wire Electrode Size焊丝尺寸: Typical Wire Diameters (0.045 in And Larger) 典型尺寸 (1.20 mm 或更大) Shielding Gases Used所用气体: 90% Ar with 10% CO2, 95% Ar with 5% O2, 98% Ar with 2% CO2, or 98% Ar with 2% O2 Pulse Spray Transfer 脉冲喷射过渡 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. * Stable CV Transfer Modes 稳定的CV过渡模式 Short Arc 短路过渡 Globular Arc滴状过渡 Spray Arc 喷射过渡 WFS (current) Increasing 送丝速度（电流）增加 Voltage Range 电压范围 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. * STT Surface Tension Transfer表 面 张 力 过 渡 技 术 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. * Basics 基本概念 S.T.T. = Surface Tension Transfer 表面张力过渡 Research Began July 1985 1985年开始研究开发 Purpose is to develop a welding process which eliminates spatter when use 100% CO2 shielding gas 目的是为了开发一种使用CO2保护气体而没有飞溅的焊接方法 STT is a Unique GMAW Process 一种独特的气保护焊接工艺 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. * Neither CC Nor CV 既不是恒流源也不是恒压源 Based on interactive WAVEFORM CONTROL TECHNOLOGYTM 基于交互式波形控制技术 Based on High Speed Inverter Technology 基于高速逆变技术 Precision Current Controlled Short Arc 精密电流控制的短路过渡焊接 Basics 基本概念 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. * Advantages 优点 Low spatter 低飞溅量 Low fume 低烟尘 Low cost Gas 低气体成本 Controlled Heat Input 可控制的热输入量 All Position 可进行全位置焊接 Good Fusion 良好的焊接成型 Handles Poor Fit-up 适用较差的接头形式 Basics 基本概念 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. * Standard GMAW 标准的气保护焊接 Surface Tension