ZCuSnlOZn2铜合金激光表面微造型工艺试验.pdfVIP

2015年 12月 机 床 与 液 压 Dec . 2015 第 43 卷 第 23 期 MACHINETOOL 1 HYDRAULICS Vol. 43 No . 23 D O I : 10.3969/j . issn. 1001-3881. 2015. 23. 028 ZCuSn10Zn2 铜合金激光表面微造型工艺试验 曾锡琴 (武进开放大学机电工程系，江苏常州213149) 摘要：为加工出符合摩擦学性能要求的ZCuSn 10Zn2铜合金表面微造型形貌 ，采用激光微造型技术对ZCuSn 10Zn2铜合 金表面进行网格图案化处理 ，利用共聚焦显微镜和X 射线应力测定仪对加工后的试样进行表面形貌表征及残余应力测试 。 考察不同工艺参数对材料耐磨损性能的影响 。结果表明 ：激光微造型后材料的表面粗糙度随激光功率的增大先减小后增 大 ，微沟槽的深度随激光功率的增大先增大后减小 ，微沟槽的宽度与工作电流成正相关 ，但随电流的增大趋于饱和 。表 面残余应力随工作电流增大趋势明显 ，微造型后 ，表层存在较大的残余拉应力 。试验结果对深人探索ZCuSn 10Zn2 铜合金 的激光微造型工艺提供了-定的数据基础 。 关键词：ZCuSn 10Zn2铜合金 ；激光微造型 ；形貌 ；残余应力 ；工艺试验 中图分类号：TH 117. 1 文献标志码 ：A 文章编号：1001-3881 (2015) 23-104-5 Experiment Process Study of Laser Surface Micro-texturing onZCuSn10Zn2 Alloy Z EN G X iq in ( Department of Mechanical and Electrical Engineering，W ujin Open U niversity ， Changzliou Jiangsu 213149, C hina ) Abstract ： In order to obtain the excellent tribology morphology of ZCuSn 10Zn2 alloy ，laser surface texturing process was used to perform paterning on specimen surface. Confocal microscopy and X ray stress meter were utilized to test tlie surface morjDhology and re­ sidual stress. The effect of diferent laser parameters on anti-wear performance was investigated. Results show increases with the increasing of laser power. With the increasing of laser power ，the depth of crease. Positive correlation bet^veen worl^ing electric current and wicith is found. A large resi(iual tensile stress remained on the treated surface which has a obvious ascend trend with the increasing working electric current. The study provides a basic data for further inves­ tigating of