一种传统互感器和电子式互感器的校验方法 .pdfVIP

学兔兔 第5O卷 总第575期 电测与仪表 Vo1．50 NO．575 2013年 第l1期 Electrical Measurement Instrumentation Nov．2013 一 种传统互感器和电子式互感器的校验方法 申妍华1 ， 潘峰 (1．华南理工大学，广州510640；2．广东电网公司电力科学研究院，广州510080) 摘要：提出一种校验传统互感器和电子式互感器的方法，该方法基于同步采样和离散傅里叶变换(discrete foruier transformation，DFT)算法。根据该方法建立了传统互感器和电子式互感器的校验系统，详细分析了影响 校验系统测量准确度的因素，并采用补偿方法提高测量准确度。校验系统在国家高电压计量站进行了校准测 试，测试结果表明系统满足校验0．2及以下等级测量用互感器的准确度要求。 关键词：传统互感器；电子式互感器；校验系统；比值误差；相位误差 中图分类号：TM933 文献标识码：B 文章编号：1001—1390(2013)11-0014—04 A Calibration Method for Conventional and Electronic Transformers l 2 SHEN Yan—hua，PAN Feng (1．South China University of Technology，Guangzhou 5 1 0640，China．2．Electric Power Research Institute of Guangdong Power Grid Corporation，Guangzhou 5 1 0080，China) Abstract：A method for calibration of conventional and electronic transformers is proposed．It is based on synchronization sampling and discrete foruier transformation (DFT)algorithm．According to the method。the calibration system has been founded．The factors that affect measurement accuracy of calibration system are thoroughly analyzed and the compensation method is adopted to improve the accuracy of the system．The calibration system has been tested in National Center for High Voltage Measurement．The tested results show that it fulfills the requirements for calibrating transformers with precision class up to 0．2． Key words：conventional transformers，electronic transformers，calibration system，ratio error，phase error 0