1.CONDITIONSFORUSE-Vaniman.pdfVIP

1. CONDITIONS FOR USE This micro abrasive blaster may only be operated: • Indoors; • Below 6500 ft above sea level altitude; • Ambient air temperature between 40°-105°F (5-40°C); • Maximum relative humidity of 80% at 88°F; • Power supply current fluctuations does not exceed 10% of nominal value; • Under level 2 contamination conditions; • Cool, dry air only. 2. SAFETY • A lways disconnect the unit from the compressed air and power sources before beginning any maintenance. • When working with the tank wear protective glasses to protect your eyes. • Any abrasive material on the o-ring may lead to leakage and early wear of the o-ring. After filling, clean the thread and o-ring before applying the lid. • Solvents will create cracks in the jar and weaken the jar (danger of explosion!). Clean the lid and tank only with a dry cloth. Do not write or adhere anything to the jar or lid. • Check for damages on the lids and tanks regularly and replace them if there is any doubt of the structual integrity. • Before operation, check to make certain the lid is secured properly. Using the product without the lid secured will create a serious explosive hazard. • Never operate the blasting units without suitable dust extraction and appropriate protective gear. The type of dust extraction should be based on the type of dust generated. Ask the proper authorities. • Never direct the blasting material towards eyes or unprotected areas of skin. Improper use can result in risk of eye or skin injuries. • Never work with the glass door open. • Caution: Failure to wear eye protection can result in eye injury. Wear proper eye protection to protect your vision. • Do not depress the foot switch when only the compressed air supply hose is connected. The loose hose could wrap around itself and cause serious injury. • Unplug the unit from the wall before changing out the LED lights.