ARCATspec10503pen2009-1-21-PencoStorageProducts.docVIP

SECTION 10 51 13 METAL LOCKERS PART 1 – GENERAL 1.01 SECTION INCLUDES A. Heavy Duty Knocked Down Lockers. B. Locker benches. 1.02 REFERENCES A. ADAAG - Americans with Disabilities Act, Accessibility Guidelines. 1.03 SUBMITTALS A. Submit under provisions of Section 01 33 00. B. Manufacturers data sheets on each product to be used, including: 1. Preparation instructions and recommendations. 2. Storage and handling requirements and recommendations. 3. Installation methods. C. Shop Drawings: Show the following: 1. Dimensioned drawings including plans, elevations, and sections to show locker locations and interfaces with adjacent substrates. 2. Details of assembly, erection, anchorage and clearance requirements. D. Selection Samples: For each finish product specified, two complete sets of color chips representing manufacturers full range of available colors and finishes. 1.04 DELIVERY, STORAGE, AND HANDLING A. Store products in manufacturers unopened packaging until ready for installation. B. Protect locker finish and adjacent surfaces from damage. PART 2 – PRODUCTS 2.01 MANUFACTURERS A. Acceptable Manufacturer: Penco Products, Inc., which is located at: 1820 Stonehenge Drive, Greenville, NC 27858; Tel: 800-562-1000; Fax: 800-248-1555; Email: general@; Web: B. Lockers shall be GREENGUARD Gold Certified by UL Environment through the GREENGUARD Certification Program. 2.02 MATERIALS Steel: Prime grade mild cold-rolled sheet steel free from surface imperfection, capable of taking a high-grade enamel finish and in compliance with ASTM A1008.  Steel: Sheet steel components shall be fabricated using zinc-coated steel free from surface imperfection, capable of taking a high-grade enamel finish and in compliance with ASTM A879. Bolts and Nuts: Zinc plated truss fin head bolts and hex nuts. Provide only metal lockers fabricated in the United States by a single domestic manufacturer. 2.03 HEAVY DUTY LOCKERS A. H