度全国监理工程师执业资格考试工程建设合同管理考试试题.doc

2002年度全国监理工程师执业资格考试工程建设1.C 2.B 3.C 4.B 5.D 6.B 7.D 8.A 9.B 10.D 11.B 12.C 13.C 14.D 15.B 16.B 17.B 18.B 19.C 20.B 21.A 22.B 23.C 24.D 25.D 26.B 27.C 28.C 29.B 30.B 31.B 32.C 33.B 34.B 35.C 36.B 37.C 38.B 39.A 40.B 41.C 42.A 43.C 44.C 45.C 46.C 47.B 48.B 49.B 50.D 二、多项选择题 51.ABC 52.BCDE 53.ABDE 54.ACD 55.BDE 56.BCDE 57.BCE 58.ACD 59.BCE 60.ABE 61.ABCE 62.CDE 63.ABDE 64.BCE 65.ACE 66.ACE 67.AC 68.BD 69.AB 70.BD 71.CDE 72.ACDE 73.ACE 74.CDE 75.ABCE 76.ABCD 77.BCDE 78.BDE 79.BD 80.BCE 更多下载尽在/songanangmail position for future reference. Installation using special lifting pole rotor rotor lift, box spirit level to check the rotor axis neck of Yang, on both sides of the rotor should be lateral raises and numerical deviation of ≤ 0.10MM, qualified before the official lifting. Hoisting of the rotor dynamic and static clearance should be measured, rotors check clearance to prevent rotor colliding. stationary blade carrier, diaphragm and sealing upper cylinder on the inside and install the mounting bolts, bolts and bolt holes in the surface should be coated with molybdenum disulfide. Follow the manufacturers stamp marked to install good sealing ring and spring. Check the sealing ring and spring plate, shall conform to the technical requirements manufacturers drawings. Bolt: ... Measurement with measurement tools, special tools, temporary connection bolts and connection tool equipped and in good condition. The rotor shaft to have fixed, such as thrust, bearing plates fixed installation, in case of wear of the rotor is too large. The coupling gasket check measurements: measured data processing according to gasket, clean the coupling ga