coal fluent能量燃烧计算.pdfVIP

Tutorial: 3D Simulation of the IFRF Industrial Pulverized-coal Furnace Purpose The purpose of this tutorial is to simulate a realistic industrial pulverized-coal furnace and compare the results with the measured data. Prerequisites This tutorial assumes that you are familiar with the FLUENT interface and have a good understanding of the basic setup and solution procedures. Some steps will not be shown explicitly. This tutorial uses the mixture fraction/PDF model with the k-epsilon turbulence model and P-1 radiation model. If you have not used these models before, it would be helpful to refer to the FLUENT 6.2 Tutorial Guide. This is an advanced tutorial, and hence it is recommended that you refer to the 2D coal combustion tutorial before you run this. Problem Description The International Flame Research Foundation (IFRF) experimental facility is an ideal sim- ulation to validate industrial coal combustion models. Comprehensive in-flame measure- ments of temperature, species, and velocities are made in an unstaged (thus high NOx), swirl-stabilized and pulverized coal flame. The tutorial is based on an extension of the 2-dimensional simulation of this furnace by Peters and Weber [1] to 3 dimensions. Boundary conditions and material properties, where appropriate, are borrowed from this reference. One quarter periodic model is used, as illustrated in Figure 1. c Fluent Inc. June 20, 2005 1 3D Simulation of the IFRF Industrial Pulverized-coal Furnace Figure 1: Problem Figure Preparation 1. Copy the files, ifrf.msh and ifrf.c.c to your working directory. 2. Sta