at89s2051秒表.docVIP

#include AT89X051.H #define uint unsigned int #define uchar unsigned char sbit start=P3^4; //开始/暂停 sbit reset=P3^5; //清零 uchar code table[]= {0x3F,0x06,0x5B,0x4F,0x66,0x6D,0x7D,0x07,0x7F,0x6F,0x77,0x7C,0x39,0x5E,0x79,0x71}; //共阴型数码管代码 // 0 1 2 3 4 5 6 7 8 9 A B C D E F uchar tabwei[]={0xfe,0xfd,0xfb,0xf7}; //位码 uchar dispbuf[4]={0,0,0,0}; //缓存 uint count,num,dis,time; void delayms(uint xms) //延时程序 { uint i,j; for(i=xms;i0;i--) for(j=110;j0;j--); } void main() //主程序 { TMOD=0x12; //开定时器0方式2，定时器1方式1 TH0=0x38; //赋初值 200us TL0=0x38; TH1=0xd8; //10ms TL1=0xf0; EA=1; //开总中断 ET0=1; //允许T0 中断 ET1=1; //允许T1 中断 TR0=1; //开定时器0 TR1=0; //初始定时器1为0，不计数 while(1) { if(start==0) //开始/暂停键按下 { delayms(10); //等待10ms if(start==0) //确认开始/暂停键按下 { TR1=~TR1; //定时器1取反 } while(!start); //等待按键释放 } if(reset==0) //清零键按下 { delayms(10); //等待10ms if(reset==0) //确认清零键按下 { num=0; //秒清零 time=0; //毫秒清零 dispbuf[0]=num/10; //送显示 dispbuf[1]=num%10; dispbuf[2]=time/10; dispbuf[3]=time%10; } while(!reset); } } } void time_T0() interrupt 1 //定时器0 { TH0=0x47; //重装初值 TL0=0x47; count++; P3=0xfd; //显示小数点 P1=0x80; if(count==5) //扫描数码管 { count=0; P3=tabwei[dis]; //位码 P1=table[dispbuf[dis]]; //段码 dis++; if(dis==4) //扫描四个数码管 dis=0; } dispbuf[0]=num/10; //显示 dispbuf[1]=num%10; dispbuf[2]=time/10; dispbuf[3]=time%10; } void time_T1() interrupt 3 //定时器1 { TH1=0xdb; //重装初值 TL1=0xff; time++; if(time==100) //time加100次为1秒 { time=0; //time清零 num++; //秒加1 if(num==60) //秒加到60 num=0; //清零 } dispbuf[0]=num/10; //显示 dispbuf[1]=num%10; dispbuf[2]=time/10; dispbuf[3]=time%10; } ----------------------------精品word文档 值得下载 值得拥有----------------------------------------------