办公楼普通门窗工程施工方法.docVIP

办公楼普通门窗工程施工方法 办公楼普通门窗工程施工方法提要：门框、扇在安装前应检查无窜角、翘扭、弯曲、劈裂、崩缺、榫槽间结合处无松离，如有上述情况要进行修理 自合同范文 办公楼普通门窗工程施工方法 一、施工准备 1．材料 由生产厂家供应木门框，木材含水率不得超过12%，进场时应核对型号。尺寸、数量、木类。 加工质量和出厂合格证。 2．作业条件 结构工程已完成并经验收完毕，且质量符合标准要求，室内水平线己弹好。 门框、扇在安装前应检查无窜角、翘扭、弯曲、劈裂、崩缺、榫槽间结合处无松离，如有上述情况要进行修理。 门框进场后，组织涂料工将框靠墙的一面涂刷防腐涂料，刷油后分类码放平整，底层应垫平、垫高，露天堆放的应用塑料布遮盖好。 门框安装应在砌墙前或室内、外抹灰前进行；门扇安装应在饰面完成后进行。 二、操作工艺 1．门框安装 安装时应按设计图纸要求的水平标高和平面位置，按其开启方向，对应编码安放，用通线线锤作水平和吊直校正，然后用拉条与邻近固定物连接牢靠。 先砌墙前安框，应按设计要求在边框预留木砖。 2．因受条件限制及其他原因留框洞时： 在砌体中预埋木砖，每边固定点应不少于三处，其间距不大于～。用木楔墙一面，与砌体面贴紧，用木楔将框临时固定在门洞内后，用射钉或钢钉钉牢。 1)安装时应考虑抹灰层厚度，立框时与抹灰外皮平。 在砌体不留木砖时，用宽30mm，长80mm，厚～2mm直脚铁，先钉固框靠墙一面，与砌体面贴紧，用木楔将框临时固定在门洞内后，用射钉枪或钢钉钉牢。 自合同范文 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of ex