古建筑轻钢龙骨石膏板吊顶施工工艺及技术措施.docVIP

古建筑轻钢龙骨石膏板吊顶施工工艺及技术措施 古建筑轻钢龙骨石膏板吊顶施工工艺及技术措施提要：安装主龙骨吊杆：在弹好顶棚标高水平线及龙骨位置线后，确定吊杆下端头的标高，安装吊筋。吊筋用6的钢筋 古建筑轻钢龙骨石膏板吊顶施工工艺及技术措施 弹线：根据楼层标高水平线，根据设计标高，沿墙四周弹顶棚标高水平线，并沿顶棚的标高水平线，在墙上画好龙骨分档位置线。 吊挂龙骨的c型钢。作为主龙骨吊挂的承重结构。c型钢采用100mm的，间距不超过1200mm，架在第二架木柁上。相邻两根用角钢焊接进来，形成固定的网架。中间部位也焊接，作为固定吊挂灯具的受力点。放置重物的地方，要把c型钢加密。 安装主龙骨吊杆：在弹好顶棚标高水平线及龙骨位置线后，确定吊杆下端头的标高，安装吊筋。吊筋用6的钢筋，安装方法焊接固定到c型钢上，间距为900～1200mm。安装时上端与预埋件焊接，下端套丝后与吊件连接，安装完毕的吊杆端头外露长度不小于3mm。 安装主龙骨：主龙骨选用Uc50轻钢龙骨，间距不大于1200mm。主龙骨用与之配套的龙骨吊件与吊筋安装。安装主龙骨时，应将主龙骨吊挂件连接在主龙骨上，拧紧螺钉。 安装边龙骨：采用L形边龙骨，L形边龙骨一侧全部打胶。边龙骨与边木用建筑胶粘结固定。 安装次龙骨：次龙骨选用Uc50轻钢龙骨，间距为600mm。将次龙骨通过挂件吊挂在大龙骨上。安装加强龙骨：龙骨安装时，在灯具和封口的周遍加设”T”形加强龙骨。 安装横撑龙骨：横撑龙骨选用Uc50龙骨，固定间距为1000mm。隐蔽检查：在水电安装、调试、打压完毕后，应对龙骨进行隐蔽检查，合格后方可进入下一道工序。 安装石膏板：石膏板选用10mm厚的，石膏板与轻钢骨架固定的方式采用自攻螺钉固定法，在已装好并经验收轻钢骨架下面（即做隐蔽验收工作），安装石膏板，自攻螺钉间距为150～200mm。刷防锈漆：轻钢骨架罩面板顶棚吊杆、固定吊杆铁件，在封罩面板前应刷防锈漆。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abid