地基加固施工方法.docVIP

地基加固施工方法 地基加固施工方法提要：钻杆在下沉和提升时均需注入水泥浆液。钻杆下沉速度不大于1m/min，提升速度不大于2m/min，下沉与提升过程中均匀、连续的注入拌制好的水泥浆液 更多内容源自通告 地基加固施工方法 1）桩位放样 技术人员根据设计图纸和测量控制点放出桩位，桩位平面偏差不大于5mm。本标段使用三轴搅拌机。三轴搅拌桩采用旋喷成孔工艺，桩心距用红色油漆做好标记，保证搅拌桩定位准确。 2）桩机就位 桩机开到指定桩位处，并调整桩架垂直度达到2‰以上。桩机移位由当班机长统一指挥，移动前仔细观察现场情况，保证移位平稳、安全。桩位偏差不得大于30mm。 3）桩基垂直度校正 在桩架10m高处悬挂一铅锤，利用经纬仪校直钻杆垂直度，使铅锤线与钻杆平行，把钻杆垂直度误差控制在3‰以内。 4）桩长控制标记 施工前在钻杆上做好标记，控制搅拌桩桩长不小于设计桩长，当桩长变化时擦去旧标记，做好新标记。 5）水泥浆液拌制 施工前搭建好水泥的拌浆水桶，对全体工人做好详尽的施工技术交底，水泥浆液的水灰比严格控制在～。 6）搅拌桩机钻杆下沉与提升 钻杆在下沉和提升时均需注入水泥浆液。钻杆下沉速度不大于1m/min，提升速度不大于2m/min，下沉与提升过程中均匀、连续的注入拌制好的水泥浆液。钻杆提升完毕时，设计水泥浆液全部注完，搅拌桩施工结束。 7）注浆、搅拌、提升 开动灰浆泵，待纯水泥浆到达搅拌头后，按计算要求的速度提升搅拌头，边注浆、边搅拌、边提升，使水泥浆和原地基土充分拌和，提升到离地面50cm处或桩顶设计标高后再关闭灰浆泵。 8）水泥搅拌桩的搭接施工 水泥搅拌桩的搭接以及成形搅拌桩的垂直度补正是依靠搅拌桩单孔搭接套钻来实现的，以确保搅拌桩的隔水帷幕作用。水泥搅拌桩一般采用跳槽式搭接套钻式施工。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard wor