墙面砖镶贴施工工艺（五）.docVIP

墙面砖镶贴施工工艺（五） 墙面砖镶贴施工工艺（五）提要：粘贴：采用水泥：砂为1：1，掺适量面砖粘合剂拌合，不得加水。面砖留缝采用塑料十字卡，以保证面砖缝宽度一致。贴砖过程中，注意予留水、电、风管线及线盒位置 墙面砖镶贴施工工艺（五） 1施工流程 基层处理--找规矩--基层抹灰--弹线--浸砖--粘贴--擦缝 2施工要点： 基层应清理干净，用清水打湿墙面，抹1：3水泥砂浆底层。弹线：以门上口作为整砖上、下排砖，如果地面处出现窄条应调整，两侧为阴角考虑非整砖对称，阳角不得出现非整砖，单侧阴角不得出现小于1/2砖的非整砖。水平向每块砖弹出控制线，竖向每面墙的每块砖挂尼龙灰线。 选砖：面砖颜色深浅、规格必须挑选，且规格偏差要求小于1mm，贴前2h浸水并阴干。 粘贴：采用水泥：砂为1：1，掺适量面砖粘合剂拌合，不得加水。面砖留缝采用塑料十字卡，以保证面砖缝宽度一致。贴砖过程中，注意予留水、电、风管线及线盒位置。 擦缝：用水泥擦缝，先用开刀沿砖缝刮一遍，再用竹签溜缝，使砖缝干净利落。 3质量要求： 饰面砖安装必须牢固，无歪斜、缺棱掉角和裂缝等缺陷。饰面砖表面应平整、洁净，色泽协调，无变色、泛碱、污痕和显着的光泽受损处。饰面砖接缝应填嵌密实、平直、宽窄均匀、颜色一致。阴阳角处的砖搭接方向正确，非整砖使用部位适宜。实测实量：立面垂直度允许误差≤2mm，用2m托线板检查；表面平整度允许误差≤2mm，用2m靠尺和楔形塞尺检查；阳角方正允许误差≤2mm，用20mm方尺检查；接缝平直允许误差≤2mm，用5m线检查，不足5m，拉通线检查；接缝高低允许误差≤，用直尺和楔形塞尺检查；接缝宽度允许误差≤，用尺检查。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image