工程施工机电设备安全操作管理制度.doc

工程施工机电设备安全操作管理制度 工程施工机电设备安全操作管理制度提要：电气、仪表、管道和设备试运转，应严格按照单项安全技术措施进行，动转达时不准擦洗和修理，严禁将头手伸入机械行程范围内 自 工程施工机电设备安全操作管理制度 1、机械操作，要束紧袖口，女工发辩要挽入帽内。 2、机械和动力机的机座必须稳固。转动的危险部位要设防扪装置。 3、工作前必须检查机械、仪表、工具等、确认完好方准使用。 4、电气设备和线路必须绝缘良好，电线不得与金属物绑在一起；各种电动机具必须按规定接零接地，并设置单一开关；遇有临时停电或停工休息时，必须拉闸加销。 5、施工机械和电气设备不得带病动转和超负荷作业，发现不正常情况应停机检查，不得在运转中修理。 6、电气、仪表、管道和设备试运转，应严格按照单项安全技术措施进行，动转达时不准擦洗和修理，严禁将头手伸入机械行程范围内。 7、在架空输电线路下面工作应停电。不能停电时，应有隔离防护措施。起重机不得在架空输电线下面工作，通过架空输电线路时应将起重臂落下。在架空输电线路一侧工作时，不论在任何情况下，起重臂钢丝绳或重物等与架空输电线路的最近距离应不小于表规定； 输电线路电压　1千伏以下　1-20kV　35-110kV　154kV　220kV 允许与输电线路的最近距离（m）　　2　4　5　6 8、行灯电压不得超过36V，在潮湿场所或金属容器内工作时，行灯电压不得超过12V。 9、受压容器应有安全阀、压力表、并避免暴晒、碰撞、氧气瓶严防沾染油脂；乙炔发生器、液化石油气，必须有防止回火的安全装置。 10、X光或y探伤作业区，非操作人员不准进入。 11、从事腐蚀、粉尘、放射性的有毒作业，要有防护措施，并进行定期体验。 自 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological qu