基于Packet Tracer 5.0的STP VTP交换机配置实例剖析.docVIP

基于Packet Tracer 5.0的STP VTP交换机配置实例 步骤一、交换机和PC机的基本配置 步骤二、关闭交换机的所有端口，然后启用接入端口 S1(config)# int range f0/1 - 24 S1(config-if-range)# shutdown S1(config-if-range)# int range g1/1 - 2 S1(config-if-r 步骤一、交换机和PC机的基本配置 步骤二、关闭交换机的所有端口，然后启用接入端口 S1(config)#int range f0/1 - 24 S1(config-if-range)#shutdown S1(config-if-range)#int range g1/1 - 2 S1(config-if-range)#shutdown S1(config-if-range)#int f0/6 S1(config-if)#switchport mode access S1(config-if)#no shut S1(config-if)#int f0/11 S1(config-if)#switchport mode access S1(config-if)#no shut S1(config-if)#int f0/18 S1(config-if)#switchport mode access S1(config-if)#no shut (交换机S2、S3配置参考S1) 步骤三、配置中继链路和本征VLAN S1(config)#int range f0/1 – 4 S1(config-if-range)#switchport mode trunk S1(config-if-range)#switchport trunk native vlan 99 S1(config-if-range)#no shut (交换机S2、S3配置参考S1) 步骤四、配置VTP S1(config)#vtp mode server Device mode already VTP SERVER. S1(config)#vtp domain cisco Changing VTP domain name from NULL to cisco S1(config)#vtp password cisco Setting device VLAN database password to cisco S2(config)#vtp mode client Device mode already VTP CLIENT. S2(config)#vtp domain cisco Changing VTP domain name from NULL to cisco S2(config)#vtp password cisco Setting device VLAN database password to cisco S3(config)#vtp mode client Device mode already VTP CLIENT. S3(config)#vtp domain cisco Changing VTP domain name from NULL to cisco S3(config)#vtp password cisco Setting device VLAN database password to cisco 步骤五、在S1(VTP Server)上配置VLAN S1(config)#vlan 10 S1(config-vlan)#name staff S1(config-vlan)#exit S1(config)#vlan 20 S1(config-vlan)#name students S1(config-vlan)#exit S1(config)#vlan 30 S1(config-vlan)#name guest S1(config-vlan)#exit S1(config)#vlan 99 S1(config-vlan)#name management S1(config-vlan)#exit (配置至此，用#sh vlan brief命令查看S2、S3交换机的vlan配置，会看到VTP Server已经将VLAN信息传播至两个交换机) 步骤六、为各个VLAN分配接口 S1(config)#interface range fa0/6 - 10 S1(config-if-range)#switchport access vlan 10 S1(config-if-range)#interface range fa0/11-17 S1(config-if-range)#swi