建筑公司电焊工职责.docVIP

建筑公司电焊工职责 建筑公司电焊工职责作者：佚名 时间：2017-5-19 浏览量： 建筑公司电焊工职责 一、电焊机外壳必须接地良好，要设单独的开关，必须绝缘良好。 二、严禁在带压力的容器或管道上施焊、焊接带电的设备必须先切断电源。 三、把线、地线、禁止与钢丝绳接触，更不得用钢丝绳或机电设备代替零线，要有地线接头，必须连接牢固。 四、多台焊机在一起集中施焊时，焊接平台或焊件必须接地，并应有隔交板。 五、雷电时，应停止露天作业。 六、施焊场地周围应清除易燃、易爆物品或进行覆盖、隔离。 七、必须在易燃、易爆气体或液体扩散区施焊时，应经有关部门检试许可后，方可施焊。 八、工作结束，应切断焊机电源，并检查操作地点，确认无起火危险后，方可离开。 九、氧气瓶、氧气表及焊割工具上严禁沾染油脂。乙炔发生器的零件和管路接头，不得采用紫铜制作。夜间添加电石英钟，严禁用明火照明。乙炔发生器应每天换水。 十、乙炔发生器，不得放置在电线的正下方，与氧气瓶不得同放在一处，距易燃易爆物品和明火的距离，不得少于10m。 十一、氧气瓶应有防震胶圈、旋紧安全帽，并防止曝晒。冻结液用热木加热，不准有火烤。 十二、点火时，焊枪口不准对人。正在燃烧的焊枪不得放在工作件地面上，带有乙炔和氧气时，不准入在金属容器内. 十三、不得手持连接胶管的焊枪爬梯、登高。严禁在带压的容器或管道上焊、割，带电设备应先切断电源。 十四、电石应放在通风良好、不漏雨、干燥的地方，移动 将桶上的小盖打开。 十五、铅焊时，场地应通风良好，皮肤外露部分应涂护肤油脂，工作完毕应洗漱。 十六、工作完毕，应将氧气瓶气阀关好，检查操作场地，确认无明火危险，方准离开。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological