使用SAM–BA调试的初始步骤.docVIP

使用SAM-BA调试的初始步骤 AT91SAM7S板可以使用SAM-BA?软件通过DBGU或者USB口编译。但是AT91SAM7S 系列芯片，出厂后并没有将SAM-BA Boot 固件复制到FLASH 存储器的头两个区，所以当第一次通过USB 连接目标板和PC 机的时候，需要按照“以下的步骤来复制SAM-BA Boot 固件到FLASH 并运行。 1.关闭AT91SAM7S板电源； 2.把板上的TST跳线连接； 3.打开AT91SAM7S板电源； 4.等10秒； 5.关闭AT91SAM7S板电源； 6.把板上的TST跳线断开； 7.打开AT91SAM7S板电源； 8.安装USB驱动程序：插上USB线，将提示“无法识别的硬件”，此时可以安装atm6124驱动程序 9.打开“SAM-BA GUI”，就可以接着使用USB口下载文件到AT91SAM7S板。 SAM-BA调试的硬件要求: - DBGUG的硬件要求 使用3～20MHz的石英震晶(软件自调适)； - USB的硬件要求 使用18.432MHz的石英震晶； USB的PIOA16口需要上拉电阻； /dev/SAM-BA%20Notes.htm SAM-BA Notes V1.0 - May 2005 The below procedure is applicable to: AT91SAM7S32 AT91SAM7S64 starting from rev E (product ID: 58814E)AT91SAM7S128 AT91SAM7S256 starting from rev C (product ID: 58818C) Getting Started with SAM-BA on?the?SAM7S-EK Evaluation Kit The AT91SAM7S-EK is ready to use the SAM-BA? software through DBGU or USB. Before being able to use SAM-BA, a recovery procedure which consists?of copying the SAM-BA Boot Assistant into Flash must be performed as follows: Power down the SAM7S-EK Close the Jumper JP5 named TST Power up the SAM7S-EK Wait 10s Power down?the SAM7S-EK Remove the Jumper JP5 named TST Power up the SAM7S-EK SAM-BA Boot Assistant is now available in the first two sectors of the on-chip flash and ready to use. ? Then, you can start using the SAM-BA GUI to interface with the SAM-BA Boot Assistant as described in the SAM-BA User Guide available in the on-line help. How to use?SAM-BA on?your?AT91SAM7S-based devices application ? The AT91SAM7S?devices feature the System Recovery procedure which?restores the SAM-BA? Boot Assistant inside the Flash. System Recovery Procedure? When the TST pin is set during power-up and PGMEN0, PGMEN1 and PGMEN2 are set, the device is entering is a specific test mode and performs a SAM-BA? Boot?System Recovery?which consists in copying the SAM Boot Assistant (SAM-BA?)?in the first two sectors of the on-chip Flash memory. The system recovery procedure takes 10s.In normal mode, the TST pin can b