插口式脚手架安全操作要点.docVIP

插口式脚手架安全操作要点 插口式脚手架安全操作要点提要：插口架不得超过建筑物两个开间，最长不得超过8m，宽度不得超过1m。钢管组装的插口架，其立杆间距不得大于2m 源自房地产资料下载 插口式脚手架安全操作要点 插口式脚手架：分为甲、乙、丙3种，甲型插口架适用于外墙板上有窗口部位的施工；乙型插口架适用无外墙板部位施工；丙型插口架适用于无窗口部位施工。插口架的安全操作要点： 1.插口架允许负荷最大不得超过1176N／m2，脚手架上严禁堆放物料，人员不得集中停留。 2.插口架提升或降落，应使用塔式起重机等起重机械，必须用卡环吊运，严禁任何人站在架子上随架子升降。 3.插口架不得超过建筑物两个开间，最长不得超过8m，宽度不得超过1m。钢管组装的插口架，其立杆间距不得大于2m，大、小面均须设斜支撑；焊接的插口架，定型边框为立杆的，其立杆间距不得大于，大面要设剪刀撑。 4.插口架上下两步脚手板，必须铺满、铺平、固定牢固。下步不铺板时要满挂水平安全网。上下两步都要设两道护身栏，立挂密目安全网，横向水平杆间距以～1m为宜。 5.插口架外侧要接高挂网，其高度应高出施工作业层1m，要设剪刀撑，并用密目安全网从上至下封严，安全网下脚要封死扎牢。相邻插口架应在同一平面，接口处应封闭严密。 6.甲型插口架别杠应大于10cm×10cm优质木方。别杠要别于窗口的上下口，每边长度要长出窗口200mm。上下别杠的立杆与横杆连接处应用双扣件；丙型插口架穿墙螺栓端部的螺纹应采用梯形螺纹扣，用双螺母锁牢。 7.插口架安装操作顺序：甲型插口架应”先别后摘”，”先挂后拆”。丙型插口架应在安装时先锁紧螺母，后摘去卡环；在拆除时，应先挂好卡环，后拆掉螺母。 8.结构外墙是现浇钢筋混凝土的，其强度应达到70％以上，才能安装插口架。 9.插口架安装后必须经过检查验收，合格签字，才能使用。 源自房地产资料下载 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, goo