施工塔式起重机顶升（降塔）安全技术交底.doc

施工塔式起重机顶升（降塔）安全技术交底 施工塔式起重机顶升（降塔）安全技术交底提要：工作前应检查顶升机构的钢结构的焊缝、连接螺栓、轴销的完好性。检查钢丝绳及导架、导轮的机械性能 更多精品：总结 施工塔式起重机顶升（降塔）安全技术交底 施工单位： 工程名称分部分项 工程工种 1．塔式起重机的顶升加节必须由取得专业队资源的队伍进行，并应有技术和安全人员在场进行监督和监护。 2．参加作业人员必须戴好安全帽、系好安全带、穿软底鞋，工具装入工具袋内。使用前必须进行检查，不合格者必须更换。 3．工作前应检查电气的完好性、液压系统是否正常、液压油是否能满足要求、液压油管的完好性。液压工作压力是否正常。 4．工作前应检查顶升机构的钢结构的焊缝、连接螺栓、轴销的完好性。检查钢丝绳及导架、导轮的机械性能。 5．检查发现的隐患必须经过处理合格后方能进行顶升或降塔。 6．顶升前应将变幅小车开至平衡处，锁定旋转机构。 7．顶升时应检查顶升横梁完全进入顶升踏步内，旋转机构与标准节的连接螺栓拆除后方能开动液压顶升系统将塔吊上部与标准节脱离。 8．顶升过程中应注意液压系统的状况及工作压力。 9．更换踏步时应检查踏步是否全部进入或脱离。 10．加节时应将新进入的标准节与原标准节完全连接牢固后，方能继续进行下一步的工作。 11．顶升或降塔工作结束前应检查各种安全限位和保险。顶升后应检测塔吊的垂直度。 12．禁止向下抛掷材料及工具。 13．工作时应设立警戒区派出专人监护。设立安全告示。 14．大雨或六级以上的大风禁止进行顶升作业。 15．现场补充交底内容： 交底人签字： 日期： 接受人（全员）签字： 注：本交底一式三份，班组、交底人、资料保管员各一份 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set