氩弧焊机操作规程（三）.docVIP

氩弧焊机操作规程（三） 氩弧焊机操作规程（三）提要：高频引弧的焊机，其高频防护装置应良好，亦可通过降低频率进行防护；不得发生短路，振荡器电源线路中的联锁开关严禁分接 源自房地产资料 氩弧焊机操作规程（三） 1．氩弧焊机的使用应执行jGj33-2001第节，第节，第节的规定。 2．应检查并确认电源、电压符合要求，接地装置安全可靠。 3．应检查并确认气管、水管不受外压和无外漏。 4．应根据材质的性能、尺寸、形状先确定极性，再确定电压、电流和氩气的流量。 5．安装的氩气减压阀、管接头不得沾有油脂。安装后，应进行试验并确认无障碍和漏气。 6．冷却水应保持清洁，水冷型焊机在焊接过程中，冷却水的流量应正常，不得断水施焊。 7．高频引弧的焊机，其高频防护装置应良好，亦可通过降低频率进行防护；不得发生短路，振荡器电源线路中的联锁开关严禁分接。 8.使用氩弧焊时，操作者应戴防毒面罩，钍钨棒的打磨应设有抽风装置，贮存时宜放在铅盒内。钨极粗细应根据焊接厚度确定,更换钨极时,必须切断电源。磨削钨极端头时,操作人员必须戴手套和口罩,磨削下来的粉尘,应及时消除，钍、铈、钨极不得随身携带。 9.焊机作业附近不宜装置有震动的其他机械设备，不得放置易燃、易爆物品。工作场所应有良好的通风措施。 10．氮气瓶和氩气瓶与焊接地点不应靠得太近,并应直立固定放置,不得倒放。 11．作业后，应切断电源，关闭水源和气源。焊接人员必须及时脱去工作服，清洗手脸和外露的皮肤。 源自房地产资料 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum sys