CPC芯材Mo70-Cu的熔渗法制备及加工性能.pdfVIP

学兔兔 第13卷第6期 粉末冶金材料科学与工程 2008年12月 Vb1．13 NO．6 Materials Science and Engineering of Powder Metallurgy Dec 2008 CPC芯材Mo70．Cu的熔渗法制备及加工性能 刘金文，王志法，古 一，吴化波，佘 惺，张启旺 (中南大学 材料科学与工程学院，长沙 410083) 摘 要：Mo70。Cu复合材料，由于致密度较低，常在后续轧制加工时出现严重的边裂。为了提高该复合材料的致 密度和轧制性能，作者采用熔渗法制备Mo70．Cu复合材料，并对其样品进行冷轧实验，研究熔渗保温时间对密 度和塑性的影响。实验结果表明，Mo70．Cu复合材料的密度及相应的加工性能均随保温时间的延长而提高，冷轧 时的变形率达40％时，样品仍未出现宏观边裂现象，可以满足对CPC芯材的要求。 关键词：Mo—Cu复合材料；致密度；烧结；冷轧 中图分类号：TG 1l3．25；TG 146．4 文献标识码：A 文章编号：1673—0224(2008)6-356-05 Preparation of CPC core material-- Mo70一Cu composite and study of rolling—capability LIU Jin wen，WANG Zhi—fa，GU Yi，wu Hua—bo，YU Xing，ZHANG Qi—wang (School of Material Science and Engineering，Central South University，Changsha 4 1 0083，China) Abstract：Because of low density,the Mo70一Cu composite material experiences bound fracture in follow-up cold rolling， which hinders itself to be a good core material for CPC composite materia1．In order to advance the density and rolling—capability of the Mo70-Cu composites，it was prepared by infiltration process at first，and then cold rolled as well as density was measured by drainage and microstructures were investigated by SEM and metalloscope．The results show that the density of the Mo70一Cu is increased with the extension of the thermal hold time，which obviously improves the cold rolling-capability of the Mo70一Cu composite，and the bound fracture of the rolling specimen is never occurred even the deformation amount of the rolling specimen goes up to 40％．All those