MoSi_2与WC-Co对磨时的磨损特性研究.pdfVIP

学兔兔 第28卷第4期 粉末冶金技术 Vo1．28。No．4 2010年8月 Powder Metallurgy Technology Aug．2010 干摩擦条件下SiC／MoSi2 ：l= 与WC—Co对磨时的磨损特性研究 席俊杰 一 吴 中 1)(郑州航空工业管理学院 机电工程学院，郑州 450015) 2)(新乡学院机电工程学院，河南新乡 453003) 摘 要： 采用扫描电镜和能谱仪观察和测定了SiC／MoSi 复合材料与WC—Co对磨试样的磨损表面和磨屑的 形貌及成分，研究了SiC／MoSi，复合材料与 WC—Co摩擦副的干摩擦磨损性能和磨损机理。研究结果表明： SiC／MoSi，复合材料与WC—Co摩擦副的主要磨损机制在初始磨损阶段主要由微观断裂机制控制，并伴有粘着 磨损、磨粒磨损和氧化磨损；在稳定磨损阶段由粘着磨损机制控制，并伴有微观断裂和氧化磨损。SiC／MoSi， 复合材料与硬度较大的WC—Co磨轮对磨时的磨损率比与硬度较小的CrWMn钢磨轮对磨时的磨损率低。 关键词：SiC／MoSi，复合材料；WC．Co；干摩擦；磨损机理 Research on wear properties of SiC／MoSi2 composites against WC-Co under dry friction condition Xi Junjie”，Wu Zhong 1)(School of Mechatronics Engineering，Zhengzhou Institute of Aeronautical Indust~ Management，Zhengzhou 450015，China) 2)(Mechanical and Electrical Engineering College，Xinxiang University，Xinxiang He’nan 453003，China) Abstract：Appearance and composition of wear surface and wear debris of SiC／MoSi2 composites tabbing against WC— Co were observed and determined by meansof SEM and EDS．The dry friction and wearproperties and wear mechanism of SiC／MoSi2 composites rabbing against WC—Co were studied．The results of research show that the wear mechanism of SiC／MoSi2 composites rabbing against WC—Co is mainly microfracture companied with adhesive wear， abras