煤炭学报(英文模板).docVIP

JOURNAL OF COAL SCIENCE ENGINEERING (CHINA) DOI 10.1007/s12404-011-0101-9 pp 1–5 Vol.17 No.1 Mar. 2011 ( Research on virtual dynamic optimization design for NC machine tools( HU Ru-fu1,2, CUI Zhong-hua1, CHEN Xiao-ping1, SUN Qing-hong2 1. School of Transportation and Traffic, Ningbo University of Technology, Ningbo 315016, China 2. Department of Mechanical Engineering, Southeast University, Nanjing 210096, China ? The Editorial Office of Journal of Coal Science and Engineering (China) and Springer-Verlag Berlin Heidelberg 2011 Abstract In order to obtain the distribution rules of abutment pressure around the 1151(3) fully mechanized top-coal caving (FMTC) face of Xieqiao Colliery, the KSE-Ⅱ-1 type bore-hole stress gauges were installed in the tailentry and headentry to measure the mining-induced stress. The distribution rules of the front and side abutment pressure were demonstrated. The results show that distribution rules of stress are obviously different in the vicinity of the face and entries. The peak value of abutment pressure in the protective coal pillar and face are located commonly in front of the working face along the strike, and they are located at the stress-decreased zone near the face. There is no stress peak value in the lateral coal mass beside the headentry in front of the face on the strike, and the peak value of abutment pressure appears at the rear area of the face. There are stress peak values both in the protective coal pillar and in the lateral coal mass beside the headentry to the dip. Keywords fully mechanized top-coal caving face, abutment pressure, in-situ measurement Introduction Conventional products development requires the processes of designing, trial-manufacture of the physi- cal prototype, test, modification, retrial-manufacture, and so on. This causes long time consuming and high cost. With the rapid development of the computer technology and its widened application to mechanical engineering,