湿式铜基烧结金属摩擦片胶粘工艺研究.pdfVIP

学兔兔 第 19卷第4期 粉 末 冶 金 工 业 Vol_19 No．4 2009年8月 P0WDER METALLURGY INDUSTRY Aug．2009 湿式铜基烧结金属摩擦片胶粘工艺研究 许成法，鲁乃光 (杭州粉末冶金研究所，浙江 杭卅I 311203) 摘 要：烧结金属摩擦片摩擦层与芯板的联接通常是通过加压烧结来实现，该工艺虽然结合强 度较高，但存在若干缺点，如：钢芯板经烧结后发生退火，硬度和强度显著降低；另一方面，加压 烧结时必须用传压垫板，增加了能耗，同时产品易出现压偏的情况，摩擦层内的低融点成分易 被挤压而流出，从而降低摩擦性能，产品的外观质量也受到影响。本文研究了一种湿式铜基烧 结金属摩擦片摩擦层与芯板连接的新工艺一胶粘工艺，旨在克服压烧工艺的上述缺点，以提高 生产效率，降低生产成本。 关键词：湿式；铜基；烧结金属摩擦片；粘贴 中图分类号：TF125．9 文献标识码：A 文章编号：l006—6543(2009)04—0020—04 STUDY ON C()NGLUTINATING PROCESS FOR C()PPER BASE SINTERED FRICTION DISC RUN IN LUBRICATION C0NDIT10N XU Cheng-fa，LU Nai-guang (Hangzhou Powder Metallurgy Research Institute。Hangzhou 3 ll 203，China) Abstract：The conglutination between frictional layer and core—plate of the sintered metal fric— tion disk is usually obtained by the press—sintering process．Although the bonding strength is high，but it has many shortcomings，such as，annealing during sintering，reducing obviously core—plate hardness and strength necessity of using pressure transmission plates，increasing energy consumption。and extrusion OUt of lower—melting point ingredients in the layer deteri— orating friction performance，and appearance of the product．A new adhibiting process was studied to overcome above mentioned shortcomings，increase the production efficiency and re— duce the cost． Key words：wet；copper base；sintered friction disk；adhibiting 摩擦片是各种机械设备中最重要的零件之一。 属摩擦片的应用范围一直在扩大，它的优点是结合 摩擦片要可靠地工作必须具有足够高且稳定