铸铁轴承座载荷计算及结构分析.pdfVIP

Vol. 32 No. 4 # 538 # FOUNDRY ECH NOLOGY Apr. 2011 1 2 1 1 3 李晓磊 , 郭学锋 , 陈 平, 徐春杰 , 原年亮 ( 1. , 710048; 2. , 454000; 3. , 454000) :根据皮带运输机托辊用铸铁轴承座的实际工作情况, 推导了计算铸铁轴承座径向载荷的 布公式采用 Pro/ E 软件建 立了轴承座模型, 在结构进行优化的基础上, 利用 ANSYS 软件对优化后的模型进行了结构 析, 通过利用 Pro/ E Mechanica 和ANSYS Work Bench 商业软件轴承载荷加载方法表明本文中计算轴承座载荷 布方法可行 : 轴承座; 载荷 布; 结构优化; 结构 析 : G251 : A : 1000-8365( 2011) 04-0538-05 Structure Analysis and Load Distribut ion Calculat ion of Cast Iron Bearing Base 1 2 1 1 3 LI Xiao-lei , GUO Xue-feng , CHEN Ping , XU Chun-j ie , YUAN Nian-liang 1. School of Materials Science Engineering, Xi. an University of Technology, Xi. an 710048, China; 2. School of Materials Science Engineering, Henan Polytechnic University, Jiaozuo 454000, China; 3. Jiaozuo Creation Machinery Manufacturing Co. , Ltd. , Jiaozuo 454000, Henan, China) Abstract: Based on t he working analyzing of cast iron bearing blocks which being as the support of carrying roller in belt conveyer, an calculation formula was developed to analyzing t he load distribut ion of cast iron bearing blocks under working condition. The 3- D model of the bearing block was built and then the st ructure of t he bearing block was opt imized by using Pro E software. By using the developed formula, t he structure of t he bearing block was analyzed by using ANSYS software. In order to prove the rightness of the developed formula, the structure was also calculated by using two commercial softwares of Pro E Mechanica and ANSYS Work Bench. The results shown the developed formula is available to evaluate t he bearing block load distribut ion. Key