EPE缓冲包装优化设计(国外英文资料).docVIP

EPE缓冲包装优化设计(国外英文资料) To be as follows: (1) the thickness of the thickness, such as 3.8 cm, must be specified to the supplier Optimized design for 1EPE design; (2) the special thickness of EPE materials can be used only for special purpose The cushion for the design of the selected item in thickness of 1.1. Therefore, no matter how much you buy, you will get the corresponding Since EPE cannot be molded, and thickness is a fixed piece of material, the sequelae. More stock, which leads to more storage and less turnover; Carried out The design of its structure is complicated. So little, youre going to have to order a special thickness of EPE for every single one, and youre going to increase the production cycle, EPE is made from a piece of fixed thickness, so it increases the cost of the buffer, and even the wrong time. There is a difference between performance and its horizontal buffering performance. Therefore, setting the EPE thickness to 4cm will increase the cost, but relative to the purchase It is the best way to measure the thickness of EPE by using a material tester to measure its performance. Design of the design and corresponding optimization. EPE structure design Cushion thickness is based on the following: 2.1 stiffness T 2 CHIG (1) in the process of structural design, unavoidably will encounter such a situation, namely, according to the theory Deadline: 2006-06-08 Author introduction: zhang waves (1982), male, anyang, henan, shaanxi university of science and technology reading master graduate student, major is cushion packaging structure design and simulation of cushion packaging. 211 Its a very real thing, and its a real thing Package Z PACKAGINGENGINEERINGVol. 27No. 62006.12 The derived EPE buffer (t = 0 deters) is a small number and the EPE thickness is 0.005 m, so the cost of using a hot melt adhesive for EPE is 6 If value, then according to the value cannot be calculated or will bow} : yuan/m2, with steam iron plate bonding costs $4 m20 (1) the overall