UPS设备容量计算方法(国外英文资料).docVIP

UPS配置容量计算方法(国外英文资料) The UPS capacity calculation is simple 2010-03-10 10:02 The calculation method of battery capacity The capacity of the battery must be the capacity provided by the load at the prescribed voltage and time. Below is a description of the capacity calculation: The necessary conditions for calculating the capacity Discharge current It is necessary to specify the increase and decrease of the load current in the discharge process and the variation of the current over time. Time of discharge The maximum expected load time. C, the lowest battery temperature The temperature condition of the battery placement is determined in advance, which determines the lowest temperature of the battery. The average setting is 50C indoors, set to -50c in a particularly cold area. Use air conditioning to ensure indoor temperature as the minimum temperature. D, the minimum voltage permitted Minimum voltage (V/single lattice) = (voltage loss)/serial number of the minimum voltage allowed by the load A formula for calculating the capacity C = 1 times [K1I1 + K2 (I2 - I1),,,,, and KN (IN -1)/L C: the rated discharge rate of 250C (AH), and,, and UXL batteries are 10HR capacity. L: the correct value for the change of capacity due to the maintenance factor, the number of years used, and the variation of the conditions of use. The average L value is 0.8. K: the amount of time that is determined by the minimum voltage of the discharge time T, the lowest temperature of the battery, and the minimum voltage permitted. I: discharge current Subscript 1, 2, and N: the order of the discharge current is added to T, K, and I Examples of capacity calculation A, discharge current 140A (A certain) B, the discharge time is 30 minutes C, the lowest battery temperature - 550C D, a minimum voltage of 1.6 V/g On these terms, we get K = 1.1 C = 1 X1.1 X140 = 192 (AH / 10HR) / 0.8 So, you can use ux2220 minus 2. Note: the above example is the calculation of a simple load type battery capacity for dis