低应变标准(国外英文资料).docVIP

低应变规范(国外英文资料)8 low strain gauge8.1 rangeThe method of 8.1.1 is used to detect the integrity of the pile body and determine the degree and position of the defect of the pile.The length of the effective detection pile length of 8.1.2 method shall be determined by the field experiment.8.2 instrument setThe main technical performance indicators of the inspection instrument shall meet the current industry standard, the JG/T 3055The relevant regulations shall have the function of signal display, storage and processing.The 8.2.2 transient vibration device should include the hammer and hammer that can stimulate wide pulse and narrow pulse. The hammer can be loaded with strong sensing; The steady-state vibration device should include the vibration force tunable and the electromagnetic steady-state exciter of 10 ~ 2000Hz.8.3 spot testThe article 8.3.1 shall meet the following requirements:1 the strength of the body shall conform to the provisions of article 3.2.6 of this specification.The material, strength and section size of the pile should be equivalent to the pile body.The top of the pile should be flat, compacted and perpendicular to the axis of the pile.The 8.3.2 test parameter setting should meet the following rules:The length of time period of the record of a time domain should be no less than 5ms after 2L/c. A frequency signal analysisThe frequency limit should not be less than 2000Hz.The pile length shall be the length of the construction pile at the top of the pile, and the area of the pile shall be the area of construction.The three velocity can be set according to the test value of the same type of pile in this area.The sampling interval or sampling frequency should be selected according to the pile length, the speed of the pile and the resolution of the frequency domain. The time domain letterThe number of sampling points should not be less than 1024.The set of the sensor shall be set according to the calibration result.Measuring sensor installation and vibratio