受拉钢筋搭接长度(国外英文资料).doc

受拉钢筋搭接长度(国外英文资料)The length of the tensile steel and the length of the drawing, as indicated in the drawing, are not indicated:C20 C25 is higher than C25Level 1 steel bar 35d 30d 25dLevel 2 steel bar 45d 40d 35dThree levels of steelThe cold-drawn low-carbon steel reinforcement is not less than 300mmIn the 03G101, there is also the calculation of the length of the tensile strength of the tensile steelCorrection factor according to the longitudinal reinforcement area percentage of lap joint determine: 25% or less take 50% 100% 1.6 1.4 1.25And in any case the lap length is not less than 300mm;The length of the compression bar is calculated by 0.7In the middle, the two bars have certain overlap length and the connecting method of wire binding is applied to the smaller diameter of the steel bar. It is commonly used for reinforcing reinforcement mesh in concrete, and it is arranged evenly, without welding.In the specification of design of concrete structure: the axial tension of the axial tension and the small eccentricity are not allowed to use the binding joint.When tensile steel diameter d 28mm and compression steel diameter d 32mm, it is unfavorable to use the lashing jointThe length of a steel reinforcement is usually referred to as the length of the joint and the length of the welding seam.Here are some of the rules for binding connections for your reference.The minimum lap length of the vertical tensile steel barReinforced typeGrade of concrete strengthC15C20 ~ C25C30 ~ C35Acuity C40Light round barHPB235 level45 d35 d30 d25 dRibbed steel barGrade HRB33555 d45 d35 d30 dHRB400, RRB400-55 d40 d35 dNote 1: this table is applicable to the percentage of the acreage joint area of the vertical tensile steel bar not greater than 25%.When the percentage of the ligand joint area is between 25% and 50%, the value of the table is multiplied by the coefficient of 1.2.When the percentage of the ligand joint area is greater than 50%, the number of the table is multiplied by 1.35.