填充墙(国外英文资料).docVIP

填充墙(国外英文资料) One, material requirement Strictly control the quality of the entry block, including strength, geometry, appearance, etc. 2, block and brick are made before the masonry, water is watered thoroughly one day in advance, the brick wall is strictly prohibited. Second, the requirement of the implant 1, the position of the implant is located in the inverted module method, the first row of steel bar is 30cm, the distance is 50cm, the depth and diameter of the hole must meet the design requirements. The cleaning of the hole shall be used for special electric hair dryer to ensure the cleaning effect of the dust. The masonry can only be built after the tensile test of the wall is qualified. 4, the setting of the structure of the structure shall be arranged strictly according to the requirements of the construction drawing, the length of the longitudinal reinforcement shall meet the design requirements, and the area hoop shall be encrypted in accordance with the requirements. In the case of steel reinforcement, the length of the reinforcement shall be satisfied by the length of the reinforcement bar. Third, other requirements 1, all have strong waterproof requirements of foot room according to the rules require the use of C20 fine stone concrete (200 ㎜ high, wide and wall thickness) for casting, prior to concrete casting, summer-planting parts must be cut hair, and rinse clean with water, must ensure that vibratory compaction when casting; 2, the building materials on the floor should be kept as close to the wall as possible. 3, all prefabricated lintel must be strictly in accordance with codes for design atlas and related production, production after the completion of the ink mark up and down direction, avoid installation process reinforced position reverse; The precast beam requirement is made up 28 days in advance, and the installation must ensure that the strength meets the design requirement. Construction requirements All the walls are made of three-line poro