一种污水脱碳新方法.pptxVIP

June 2016 Petroleum Engineering Technology Research Institute Research Center for corrosion protection Tianjun Li A new method of decarbonization of carbon dioxide flooding produced water 一种CO2驱产出水脱碳新方法 1 Report outline 1、why carbon dioxide flooding is wildly used 2、the treatment method of carbon dioxide flooding produced water at present 3、Introduction of the new method 2 1、why carbon dioxide flooding is wildly used In early 1980s, the United States began to use carbon dioxide flooding, facts proved the technology is not only able to reduce carbon emissions, but also has a very high oil displacement efficiency. Carbon dioxide flooding is good for environmental protection It has a very high oil displacement efficiency 3 美国热力采油、气驱、CO2驱项目数 Carbon emissions waterflooding injection-production ratio carbon dioxide 70:1 5:1 1、why carbon dioxide flooding is wildly used In Zhongyuan Oilfield， carbon dioxide flooding is used in Shayi Reservoir in 2008. The oil production is 80t and inject 250t of carbon carbon dioxide every day in Shayi. 4 process flow diagram recycling installment injection pump Report outline 1、why carbon dioxide flooding is wildly used 2、the treatment method of carbon dioxide flooding produced water at present 3、Introduction of the new method 5 2、the treatment method at present (1) The characteristics of produced water Its PH value is very low, about 4.4. and the common produced water′s PH value is about 5.5 It contains a large number of ferric ions(Fe2+ and Fe3+), more than 100mg/L. And ferric ions in the common produced water is about 50mg/L. These two reasons make that it is highly corrosive. 6 The Ph value of carbon dioxide flooding produced water The Ph value of common produced water n[H+co2]:n[H+common]=11 Ferric ions in common produced water Ferric ions in carbon dioxide flooding produced water 2、the treatment method at present (2) The harm of strong corrosive of the produced water The maintenance costs rise. The corrosive leads to perfor