HDPE复合材料的力学及吸水性能.pdfVIP

学兔兔 钎 巍 中国科技核心期刊 聚酯纤维增强木粉／HDPE复合材料髓 力学及吸水性链 程然，王海刚，刘天，王清文 (东北林业大学 生物质材料科学与技术教育部重点实验室，黑龙江 哈尔滨 150040) 摘要：采用先开炼再挤出的成型工艺制备短切聚酯纤维(PF)增强木塑复合材料(PWPC)，分析了PF的添加量及长度对复合材 料性能的影响。实验结果表明，添加长度为2 nlln的PF时，几乎无法起到增强作用；随着PF添加量和长度的增加，PWPC的力学性 能稍有提高。当PF长度为4mlTl、添加量为6％时，其弯曲强度和冲击强度分别提高了5％和6％，表现出较好的综合力学性能；同时 耐水性能显著改善，31 d常温吸水率下降26．4％，2 h沸水吸水率下降23．4％。 关键词：木塑复合材料；聚酯纤维：开炼；力学性能；吸水率 中图分类号：TU532．3 文献标识码：A 文章编号：100l一702X(2014)04—0079—04 The mechanical properties and water absorption of polyethylene terephthalate fiber reinforced wood／HDPE composites CHENG Ran，WANG Haigang，LIU Tian，WANG Qingwen (Key Laboratory of Bio-based Material Science＆Technology，Ministry of Education， No．beast Forestry University，Harbin 150040，Heilongjiang，China) Abstract：Shon cut polyester fiber(PF)reinforced wood-plastic composites(PWPC)was prepared by open mill and extrusion molding process，the influence of the dosage and length of PF on the mechanical prope~ies’were investigated．The results indicated that the incorporation of PF with the length of 2 nm caused nO enhancement on the mechanical properties of wood flour／HDPE composite．With the increasing dosage and length of the PF，the mechanical properties of PWPC improved slightly．The PWPC contained 6wt％ PF and 4．rain length Was obtained the best mechanical properties in the test，which flexural and impact properties improved 5％ and 6％，respectively．The 31 days cold water absorption and 2 hours boiling water uptake decreased 26．4％ and 23．4％ simultaneously．