2011届西南三校二联文科综合试卷(国外英文资料).docVIP

2011届东北三校二联理科综合试卷 The second simulation of the answer _ physics qid 14 15 16 17 18 19 20 21 The answer B C AB ACD D ABC ACD C a. V (1) balance (2) (2) A D (2) (1) R2 (3) (2) 3A (0, 3A) (3) (3) (3 points) Current limiting power supply, r2 and voltmeter series voltage, in the current meter (4) 12.0 (2) 24. The solution 25. The solution (1) because of the charged particles deflect, PQ plate will take charge and set the voltage for U, plate voltage between MN to U also, when do uniform motion between the charged particles in the PQ plate, a, (2) If there is only one bright spot on the screen Y, the negative charge cannot pass through the plate MN. , (2) Solution (2 points) (2) there are two bright spots on the screen, and in this condition, , For the positive charge, lets say that the velocity is equal to the velocity in B2. Lets say that the radius of the circle is R1, and then (2 points) Have to For the negative charge, lets say that were going to go to B2 and then were going to have the velocity of 2. Lets say that the radius of the circle is R2, and then (2 points) Have to So, the ratio of the positive and negative two charges to the small holes in the fluorescence screen is more than that (2 points) 33. (1) the BD (2) (1) when the piston just left the card, the piston mg + P0S = P1S P1 = P0 + (2) The volume of the gas on both sides of the gas is constant, and the right pipe is T1 = T0 (1 +) (3 points). (2) the gas in the left tube, the length is, the pressure is: P2 = P0 + + rgL (2) Apply the ideal gas equation T2 = (P0 + + rgL) (3 points) 34. (1) B (2) solution S = (5 points) 35. (1) the BCD (2) the solution: (1) when the spring restores the original length, the speed of a slider is the maximum, The maximum velocity of a slider is the velocity of the b slider at maximum velocity By the question: 1. 2. 3. solution (2) the speed of the two slides is the same as the maximum distance between the two slides. Lets say that this is the velocity There is: 6. In 2011, thr