marshall jvm 410 中文说明书 翻译(国外英文资料).doc

marshall jvm 410 中文说明书 翻译 Marshall jvm410 pedal switch to restore factory Settings: Remove the pedal switch and switch the plug. 2 press switch # 6 (right switch). Plug in the pedal switch. When the switch switches off, the pedals FX leds start flashing. If you want to clear out the set of data, press the switch on and off # 5. If you want to keep your memory on any switch in # 1, # 4. At this point, the pedals will be restored to the factory Settings, please note that the delete Settings will not be restored once the data is deleted. The factory defaults to the following: step 1: CLEAN mode Step 2 CRUNCH mode Foot 3: OD1 mode Foot 4: OD2 mode Foot 5: the master model Step 6: reverberation patterns I. Channel, mode, memory Below, introduce the JVM speakers with four channels, 100 watts of power, and full electronic tubes (the JVM410H box head and the JVM410C 2 * 12). Each of the four channels has three modes, each has its own unique distortion design, and there are 12 modes for the user to choose to use. Before on the control panel and eight LED switch, a total of 28 knob because before and after the layout of the control panel is a personal, so it is easy to use, operation is easy. The CLEAN, CRUNCH, OD1, OD2, and OD2 channels have their own special control knobs on the front panel, as well as MASTER and reverberation control areas. Each channel has the modulation of volume, bass, medium, high, and distortion. The reverberation control area has a single knob for each channel reverberation size, which means that there are four knobs that adjust the size of the reverberation effect in the area. MASTER area, is equipped with two MASTER can use the foot pedal control knob, and can control all four channels of resonance knobs and poise knob (behind the name is so strange, bad understanding, there are detailed introduction) Four channel sons can switch three modes. They switch by selecting switches with unique modes in each channel. When choosing a channel, by pressing a