如何诊断变速器异响(国外英文资料).doc

怎样诊断变速器异响 How to diagnose transmissions? 2011-03-04 07:42:14 | : the default category | : | is large In the Small subscription How to diagnose transmissions? (l) phenomenon (1) the transmission sound refers to the transmission noise at work obviously increased, the abnormal noise, such as monotonous frequency noise, uttered the dry friction of the metal, and the clash of uneven, these are the sound of the transmission fault; The gearbox vibrates with a different noise, and can feel vibrations on the handle of the gearbox, even the hand. (2) reasons: The gear is damaged in the gearbox, the gear is damaged, the gear is damaged, the gear tooth, the tooth, the gear shaft, the inside spinner. The gear tooth is worn down and the corrosion is broken. Serious when a gear tooth broken (break or fracture. Gap between meshing gear pair and center distance increase, impact during operation; bad tooth surface meshing, a metal strip sound; a tooth fracture damage, run in sound; If the bearing is damaged in the transmission, the gearbox is worn by the gearbox for long periods of time, or for maintenance of improper maintenance. Shaft peeling and damage; Failure of bearing roller, etc. Damage to the transmission shaft; In the transmission, there are bolts, nuts and other metal objects, and a large piece of metal that is peeled off and is stirred up by oil in the running gear. Odometer gear and soft shaft ring; The gearless oil, the lubricating oil use the day long to make the oil too thick or too thin, make the gear tooth face to work the load to increase and cause the noise. The main drive gear in the gearbox is damaged by gear, gasket or bearing. (3) the elimination method: To remove the transmission, inspect or replace the gear. When the area of the tooth surface is about a quarter of the small spots, the surface of the surface of the surface of the surface of the surface of the tooth is obviously bad, the tooth surface has a depth of 0.2 mm and the shallow mark should change t