并机前提(国外英文资料).doc

并机条件 One. What is the condition of the generator set in parallel? The whole process of running a generator set is called juxtaposition. Run a generator set first and send the voltage to the mother On the line, and the other generator set up, it should be tied with the previous generator set, which should not be in the airlock There is a harmful shock current, and the shaft is not affected by a sudden shock. After the switch, the rotor should be pulled into sync quickly. ( The rotor speed is equal to the rated speed, so the generator set must have the following conditions: The effective value of the voltage in the generator set must be equal to the waveform. The phase of two generator voltages is equivalent. The frequency of two generator sets is equivalent. The two generators are in accordance with each other. Second, what is the quasi-parallel method of the generator set? How to hold the same period? The quasiperiod is the exact period. In parallel operation, the voltage of the generator set must be equal to the same frequency The phase is consistent, which can be applied to two voltmeters, two frequency tables, and the same time table and non-phase indicator lamps in the same period To monitor and coordinate operations as follows: To close the load switch on a generator set in the middle, the voltage is sent to the mother line, while the other unit is in and out. At the beginning of the same period, adjust the speed of the generator set and make it equal or close to the synchronous speed (with the frequency of the other unit The difference is within half a week, and the voltage applied to the generator set is close to the voltage of another generator. When the frequency is similar to the voltage, the rotation speed of the table is slower and slower, and the light is dark when the indicator is on. When to stay In the same time as the unit and the other unit phase, the table pointer indicates to the middle seat in the middle, the light is the darkest, when When the