_基于无光耦反激变换器的LED驱动电源设计.pdfVIP

总第49 卷 第559 期 电测与仪表 Vol.49 No.559 2012 年 第7 期 Electrical Measurement Instrumentation Jul. 2012 * 基于无光耦反激变换器的LED驱动电源设计 沈霞，李红伟，许瑾 （西南石油大学，成都610500） 摘要：传统的采用反激变换器作为主电路的LED 电源中，为了实现恒流控制及输入和输出的隔离，需要通过光电 耦合器把副边信号反馈回原边进行电路控制。但是光耦的体积大，且工作时电流传输比容易受到温度的影响， 为了减少电路器件，降低温度对电路的影响，本文采用基于原边控制的无光耦反激变换器作为电源主电路。由 于没有光电耦合器，降低了成本，减小了电源的体积，提高了功率密度，降低了温度对电源的影响。此电源能实 现LED 的亮度控制，并且能通过恒压控制实现LED 的开路保护。 关键词：LED驱动电源；反激变换器；断续模式 中图分类号：TM910. 2 文献标识码：B 文章编号：1001-1390 （2012）07-0097-04 Design of LED Driver Power Supply Based on Flyback Converter without Photocoupler SHEN Xia ，LI Hong-wei ，XU Jin （Southwest Petroleum University ，Chengdu 610500 ，China） Abstract ：In order to realize constant current control and isolation between input and output ，in traditional LED power supply using Flyback converter as main circuit ，photocoupler is needed to transfer the feedback signal from primary side to secondary side. Consider of the large size of photocoupler and the influence of current transfer ratio due to temperature variation ，the Flyback converter with primary side control is used as main circuit to decrease the number of components and the influence of the temperature. Without photocoupler the main circuit has less cost ， smaller size ，higher power density and less influence of temperature. With this power supply，the LED current can be regulated to realize the control of the lightness and the voltage of the LED can also be controlled to realize the open protection of LED. Key words ：power supply of LED ，flyback converter ，discont