光纤激光-渗氮处理对Cr12MoV钢组织和性能的影响.pdfVIP

学兔兔 铸 造 oct．2015 · 964 - F0UNDRY Vo1．64 NO．1O 光纤激光一渗氮处理对Crl 2MoV钢组织 和性能的影响 何力佳，赵晓杰，王 函 (辽宁工业大学材料科学与工程学院，辽宁锦州121001) 摘要：采用IPG的YLS一3000型光纤激光器对Cr12MoV钢表面进行原位激光．渗氮处理。通过光镜、扫描电镜、x射线 衍射及金相显微硬度计，分析研究不同激光处理参数对渗氮层组织及性能的影响。结果表明，在扫描速度和离焦量 一 定的条件下，Crl2MoV激光熔凝层深度随激光功率的增加而增大，激光渗氮处理可使材料表面显微硬度提高。 Crl2MoV钢激光渗氮后的组织由熔凝区、热影响区及基体三部分组成。随着激光熔凝速度的增大，熔凝区树枝晶逐 渐变得细小。随着激光熔凝功率的增加，熔凝区树枝晶逐渐变得粗大。熔凝层的硬度峰值出现在距材料表面1．0 mm 附近，两侧呈对称降低，硬度峰值则随激光功率的增加而增加。 关键词：Cr12MoV钢；激光．渗氮处理；显微组织；硬度 中图分类号：TG161 文献标识码：A 文章编号：1001—4977(2015)10—0964—04 Effects of Fiber Laser—Nitriding Treatment on Microstructure and Properties of Crl 2MoV Steel HE Li-jia，ZHAO Xiao-jie，WANG Han (School ofMaterial Science and Engineering，Liaoning University ofTechnology，Jinzhou121001，Liaoning，China) Abstract：The Cr 1 2MoV steel surface was treated with laser．nitriding by IPG．YLS 3000 fibre laser．By using of optical microscopy，X-ray diffraction(XRD)，scanning electron microscopy(SEN)，micro—hardness test were employed to investigate the effects of laser．nitriding treatment parameters on the microstructure and properties ofcold mold steel Cr12MoV．The results show that the nitriding layer depth increases with me increasing oflaser power．The surface microhardness increases with laser nitriding treatment．The microstructure consists of three parts ofnitriding zone，heat affected zone(HAZ)and matrix and the dendrite ofnitriding layer was refined with the increasing oflaser scanning speed．The dendrite was coarser with the