管系预制与安装工.docVIP

30,000 DWT BULK CARRIER 管系预制与安装工艺 PIPING FABRICATION INSTALLATION PROCEDURE 30kton bulk carrier 管系预制与安装工艺 PIPING FABRICATION INSTALLATION PROCEDURE 标记 数量 修改单号 签字 日期 版 号 总面积m2 旧底图登记号 编制 打字 0 校对 底图登记号 审核 共 10 页 第 1 页 标检 山海关船厂 技 术 部 审定 日期 面积：0.06 m2 管系预制与安装工艺 第 2 页 A.总则 GENERAL 范围 Scope 本工艺为碳钢管、不锈钢管、铜镍管和紫铜管在车间的预制和船上安装。玻璃钢管的工艺参见厂家工艺和ABS 规范。 This procedure is used for carbon steel 、stainless steel 、Cu-Ni pipe and copper pipe fabrication in piping shop and installation on board. Other procedure for GRP according to the manufacture’s requirements and ABS rules. 2. 应用 Application 本工艺适用于3万吨散货船的船厂负责制做管系的预制与安装。 This procedure applies to fabrication and installation of 30kton bulk carrier piping supplied by shipyard. 3. 质量控制 Quality control 船厂将按照设计图纸、ABS 规范和管系预制和安装工艺、检验工艺、压力试验工艺进行预制和安装，以保证设计要求和ABS 规范。 Shipyard will fabricate and install piping according to design drawing、ABS rules 、piping fabrication and installation procedure、supervision and inspection procedure、hydrostatic pressure test procedure. So as to ensure compliance with requirements of design and ABS rules. 4. 材料控制 Material control 4.1.管线在车间预制划线、切割之前，需按车间用图检查管材及法兰、弯头等附件是否符合要求规格。 To inspect all pipe、flange、fitting、etc according to shop drawing before marking cutting line and cutting. Ensure that the correct grade of material has been supplied and that identification, dimensions, material quality, and DNV rules preparations and tolerance are in accordance with the applicable standards specifications and DNV rules. 4．2．检查管材是否有损伤、径向凹痕、污染等，如不合格应置于另一区域。 Material found to have been damaged or contamination during transmit or period to receipt, or which is incorrectly marked, shall be immediately placed in another area separate from acceptable material with sufficient safeguards to