NBK陶板-BrightShelf_Installation_Instructions_HD.pdfVIP

BrightShelf™ Installation Instructions STEP #1: Verify site is ready for installation. BrightShelf™ is a finish product; therefore it should be one of the final elements of the interior finish of a room. Improper scheduling practices are the cause of most damage to light shelves. Ensure that all electrical, HVAC, fire sprinkler, glazing, ceiling, and painting work have been completed prior to the light shelf installation. (Carpet and flooring installation may occur, and is suggested, afterward if desired) In some cases the contractor may want to install the attachment clips and field verify center- center dimensions prior to the fabrication of the shades. In this case, the clips may be installed at any time after the substrate is in. STEP #2: Unpacking the Crate Prior to starting any installation of BrightShelf™ it is imperative that you have all the right pieces for the job. Ensure that the contents of the crate match the shipping papers and the drawings. Each crate contains boxes of BrightShelf™ sections that are clearly labeled with job name, room location mark, and shelf section mark. Each crate shall be numbered and corresponding contents listed on the shipping manifest. Care should be taken when opening the outer crate to avoid damage to the boxes packed within. BrightShelf™ boxes are stacked vertically during shipment to reduce shipping damage, and care should be taken to ensure that boxes do not spill sideways once the initial crate is broken open. STEP #3: Installing The Clips The clips and fastening hardware may be in a separate box by themselves, or within box ends. Locate and unwrap each clip individually to identify correct type for the ins