CAD教程8free form feature.pptVIP

Free Form Features模块培训 曲面的一般规则 1用点生成曲面： From Point Cloud — if you have scattered points. Through Points — if defined points form a rectangular array. From Poles — if defined points form a rectangular array. 由面形成曲面 Offset Surface Thicken Sheet Enlarge Extension Law Extension 其他特征建立曲面 Through Points Creating a Multiple Patch Sheet Body Using From Poles From Point Cloud 直 纹 面（Ruled） rule Open file: fff_ruled_by_points.prt Through curve fff_thrucurves_parameter.prt Through curve fff_thrucurves_arclength.prt Creating a Sheet with By Points Alignment with a Degree of One fff_thrucurves_by_points.prt, Through curve Creating a Sheet Body with Tangency Constraints fff_thrucurves_tangent.prt Creating a Solid Body Using Spline Points Alignment Creating a Through Curves Feature Selecting Multiple Faces Thrugh curve mesh Thrugh curve mesh fff_curvemesh_2.prt, emphasis on primary or cross Emphasis on Cross Strings Curve Mesh with Tangency Constraints fff_curvemesh_3.prt .Tangency Constraints sweep Using 2 Guide Strings, 1 Section String, and 1 Spine String 2 Section Strings, 2 Guide Strings, and 1 Spine String Using Faces as Section Strings fff_swept_faces.prt the spine string Creating an N-Sided Surface from a Closed Spline fff_n_side_loop_1.prt Multiple Triangular Patch N-Sided Surfaces fff_n_side_mesh_1.prt N-Sided Surface from a Closed Planar String of Curves fff_n_sided.prt Section Creating an Ends-Apex-Rho Section Feature with a Constant Rho fff_ends_apex_rho.prt Creating a Fillet-Shoulder Section Feature fff_fillet_shoulder.prt Creating an Ends-Slopes-Rho Section Feature with a Constant Rho fff_ends_slopes_rho.prt Creating Five-Points Section Features fff_five_points.prt Creating an Ends-Apex-Hilite Section Feature fff_ends_apex_hilite.prt Creating a Two-Points-Radius Section Feature fff_two_points_radius.prt Creating a Fillet-Bridge Feature Using Match Tangents fff_fillet_bridge_tangent.prt Creating A Fillet-Bridge Feature Using Match Curvatures fff_fi