zemax非顺序系设计教程.docVIP

如何创建一个简单的非顺序系统 Setting up Basic System Properties建立基本系统属性 We will create a non-sequential system with a?filament source, a parabolic reflector and a plano-convex lens that couples light into a rectangular lightpipe, as shown in the?layout below.我们将创造出一，抛物面反射镜和一个平凸透镜镜头成一个长方形光管灯如下面的布局显示。 We will also trace analysis rays to the detectors to obtain the irradiance distribution at various points in the optical system.我们还将跟踪分析射线探测器获得光学系统中的各点照度分布。 Here is what we will finally produce:下面是我们最终将产生： If ZEMAX is not running, please start it now.如果ZEMAX软件没有运行，启动它。 By default, ZEMAX starts in sequential/mixed mode.默认情况下，ZEMAX软件启动顺序/混合模式。 To switch to pure non-sequential mode, open ZEMAX and click FileNon Sequential Mode.要切换到纯非连续模式，ZEMAX软件，然后点击文件“非序列模式。 Once in pure non-sequential mode, the window title bar of the editor will display the Non-Sequential Component Editor instead of the Lens Data Editor when in sequential mode.一旦纯非连续模式，在编辑器窗口的标题栏将显示非连续组件编辑器而不是在连续模式时只用于连续或混合模式系统的镜头数据编辑。 The Lens Data Editor?is used?only?in sequential or mixed-mode systems. For this exercise, we will set the system wavelength, specified under SystemWavelengths, to 0.587 μm.对于本练习，我们会设置系统波长系统波长指定0.587微米。 We will also set the units under SystemGeneral Unit tab as follows (default).我们还将在系统设置单位SystemGeneral /Unit tab “一般组标签如下（默认）(default).。 In addition to radiometric irradiance unit such as Watt.cm -2 , you can specify photometric and energy units such as lumen.cm -2 or joule.cm -2 .辐射辐照装置如Watt.cm -2您可以指定光度和能源单位，如lumen.cm -2或joule.cm -2。 We will choose the default radiometric units for this exercise.我们将选择默认为这项工作辐射单位。 创建反射 Insert a few lines in the non-sequential component editor by pressing the “Insert” key on your keyboard.按键盘上的“插入”插入非编辑。  In the first part of the design, we will create a filament source collimated by a parabolic reflector.在设计的第一部分，我们将创建一个由抛物面反射镜准直。 We will then place a detector object at some distance +Z and look at the irradiance distribution on?a detector.然后，我们将在+ Z探测器对象和看在探