2011003大六角高强度螺栓连接设计加工(国外英文资料).docVIP

2011003大六角高强度螺栓连接设计加工(国外英文资料) Large hexagon high strength bolt connection 1 scope This process is suitable for the construction technology of steel structure installation engineering, large hexagonal high strength bolt connection. Construction preparation 2.1 materials: Article 2.1.1 bolts, nuts and washers shall be accompanied by a certificate of quality and shall conform to the design requirements and the national standards; The specifications, dimensions and weights of the high strength bolts of 2.1.2 large hexagonal head shall conform to the rules of table 5-4. The specifications, dimensions and weights of the 2.1.3 high strength nuts should meet the requirements of table 5-5. The specifications, dimensions and weights of the 2.1.4 high strength gasket shall be in accordance with the provisions of the table 5-6. The material performance of large hexagonal high strength bolts with different grades of 2.1.5 must meet the requirements of table 5-7. The mechanical properties and pull of the high strength bolts of 2.1.6 different specifications shall conform to the rules of table 5-8. The hardness of 2.1.7 hexagonal high strength bolts shall be in accordance with the provisions of table 5-9. 2.1.8 large hexagon head high strength bolt connection vice is written by a bolt, two gaskets, a nut, bolts, nuts and washers shall be used according to table 5-10. 2.1.9 high strength bolts shall be classified according to the specifications. Should prevent rain, moistureproof, encounter with thread injury or bolt, nut does not go together not to use. When the high strength bolts are too long, or rust, they should be checked to meet the requirement. Bolts shall not be bonded to dirt or oil and must be cleaned. 2.2 main tools: Electric torque wrench and control box, manual torque wrench, torque measuring wrench, manual wrench, wire brush, punch, 2.3 working conditions: The friction surface must meet the design requirement, and the friction factor must meet the design requirement