【matlab】 输进图像大小调剂(国外英文资料).docVIP

【matlab】 输出图像大小调整(国外英文资料) Matlab graphics window size control, plot window size, figure size, axis setup, practical ? The graphics window size controls zz when the image is saved in Matlab The first thing to understand is that Matlab is object-oriented. The highest level object is screen, which defines the largest szie you can use. Screen is the figure below. Figue is the new dialog box that pops up when you draw a picture. If the figure changes, screen doesnt change. But if screen changes, the figure will change. ? The figure below is axes. Axes is the thing that youre going to draw in that window. The size and location of axes depends on the figure, and if you zoom in on the size of the figure, the lines in the map will change as well. Set (gca, position, []) So, set (gca, position, [0.1, 0.1, 0.9]); The role of is: Set the distance from the drawing board (figure window figure). [0.1, 0.1, 0.1, 0.1] axes in the figure left boundary respectively, and the lower boundary, width, height, minimum of 0, the maximum 1 (left boundary and lower boundary is 0, on the border, right border to 1) See the following example: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- figure ? (gca, position, [0.1, 0.1, 0.9]) ? X = 1-0. 1:10; ? Y = sin (x); Plot (x, y) -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- The results are shown below: Set (GCF, position, []) The frame (graphical window) of matlab is mostly square or approximate square rectangle, can you draw some flat rectangle? You can do this using the position attribute of the graph. If set (GCF, unit, position, position, [0.2, 0.2, 0.64, 0.32]) Means: Set the position