取样长度、评定长度在粗拙度测量中的应用(国外英文资料).docVIP

取样长度、评定长度在粗糙度测量中的应用(国外英文资料) The contour spectrum is passed through the filter and the roughness of the spacing is less than that of the cutoff wavelength, and the roughness of the spacing greater than the wavelength is completely inhibited. ????? The cutoff wavelength is the wavelength of a sine wave that is measured in the contour spectrum, and is used to be called the cut length, usually called the cutoff value. So the end value of the instrument is the same as the length of the sample. Cut-off value and sampling length, is the difference between a cut-off value is a kind of means, use it to make the outline of the waveform limit to assess the effect of within the sampling length. And sampling length is used to distinguish the characteristic of the surface roughness is a baseline length, it can make the surface roughness parameter values from the degree of wave and wave distance is greater than the value of the demarcation of roughness. When recording surface contour curves from the logger, you do not have to consider the cut-off value. And when you measure it with an average scale, you have to think about the cutoff value. Cut-off value knob on the electrical box, there are usually three gears of the pitch value (to TALY - SURF - 4 contourgraph three gears for J, K, L), respectively corresponds to the 0.25, 0.8, 2.5 mm sampling length value. For the selection of cutoff value, the machining method of the measured part should be understood first, and the surface roughness value should be made preliminary, according to table 4. ????????? The evaluation length is the length of a length required to assess the roughness of the contour surface, including one or several sample lengths. ????? The length of the gauge is represented by the length of the instrument. Contourgraph measure the stroke length (meter), is used for measuring the surface roughness of a trimming contour length, namely in the measurement due to the effect filter produces a stylus movement synchroniza