公函版记中的分隔线设置(docx)(国外英文资料).docVIP

公文版记中的分隔线设置(docx)(国外英文资料) The separation line set in the document version On October 31, 2013 The party and government organs of document format (GB/T9704-2012), article 7.4.1 regulation: version of the separation line and type area wide, remember first article at the end of the separation line and the dividing line with bold lines (recommended height is 0.35 mm), in the middle of the dividing line with fine line (recommended height is 0.25 mm). The first separator line is above the first element in the edition, and the final line is overlapped with the lower edge of the board. The following is an introduction to the specific operations of the line set in the official version of Microsoft word 2010. The basic approach is to insert lines in the page layout and then to set the thickness, size and location of the line. 1. Insert line On the page, click insert | illustration | shape and pop down the drop-down menu. In the line of the drop-down menu, choose straight lines. This is shown in figure 2. After choosing the linear line, the mouse becomes a cross. At the bottom of the page, draw a straight line from left to right and finish line insertion. Tip: at the bottom of the page, place the mouse on the left cut foot, horizontal to right cut foot, release mouse, insert line. Set the line size After the line is selected, the format TAB appears in the functional area. In the format | size option group, set the line height to 0 cm, width set to 15.6 cm, complete line size setting. As is shown in. Figure 1 sets the partition line size Figure 2 insertion line Set the line thickness Select the line and click format | shape, shape outline, and pop down the drop-down menu. In the thick item in the drop-down menu, the thickness of the line is set. The first and final line is set to 1 pound, and the middle separation line is set to 0.75 LBS. This is shown in figure 3. Figure 3 sets the dividing line in thickness Tip: select 1 pound line of line, hold the right mouse button, selec