图框大小比例(国外英文资料).docVIP

图框大小比例(国外英文资料) A: how about the size of the CAD picture frame and the proportion of the drawing set? Answer: the general proposal is to press 1:1 draw picture first, the line of object 1 metre is drawn in the CAD is 1000 mm long, put in appropriate picture frame inside out diagram. Of course, you can also select a good picture frame (copy or transfer) before drawing. If you draw a picture in the model, put it in the 1:10 picture box for example: Notice one, in the diagram text height, regardless of when you draw ratio, only consider the effect of using the figure drawing frame ratio in the future, for example, if you want to in the future the text after the figure height is 3 mm, if use 1:100 drawing frame, then it is your word high by 3 * 100 = 300 mm (only in this way can after print out the map to get the actual 3 mm high characters, because 1:100 box when the map is printed out 100 times is to reduce the print). Note 2, the annotation style is set as follows: Text/literal height: 3 (or 3 ~ 5); The main unit \ measures unit scale factor: 1; Adjust scale using a global scale: \ tagging feature 100 (if the 1:1 drawing frame, choose 1; choose 10), (if the layout, general is according to the layout drawing space scale notation). CAD with mapper, printer after actual graphics ratio K depends on the figure when the CAD drawing of the proportion of the drawing ratio K1 and the drawing frame (i.e., printers, drawing ratio) of K2 both product, the proportion of the final the pattern of the figure after (drawing frame column should fill in the proportion of the proportion of) K = K1, K2. Note that the figure of 1:100 box than 1:1 drawing frame on the CAD view is big 100 times, 100 times rather than a small, because when the map is the printer out of 1:100 drawing frame and the graphics printed 100 times is actually shrinking, so figure proportion K2 is 1:100 said it out. When you print out the diagram, you define it as zooming in the drawing space. One. The graph ratio: t