18米贝雷梁栈桥计算书(国外英文资料).docVIP

18米贝雷梁栈桥计算书(国外英文资料) A calculation of 18m berley beams One, calculate basis The practical manual for calculating the static power of architectural structures; Working drawings for the construction of the project of XXX interchange; Article, the technical specifications for highway bridge construction; The design specification of highway bridge and design; 5, the handbook for the use of beret beams; Second, design points The design load is 55 tons, the bridge net width is 5.0 meters, the single span 18 meters, the bridge length is 72 meters. The bridge is laid side-by-side with 0.15 m by 0.15 m square, and under the square of the I20, the I20 is the beam of I20 steel, which is set up on the girder of the beret beam. 3, bridge platform, pier, foundation stone concrete. It is arranged into a scaffold beam with home-made beret brackets, and the structure of the scaffold is arranged in a simple arrangement. Three, the construction load calculates the value Seller, dead load, 1, square wood takes 7.5 KN/m3. (2) the steel structure takes 78KN/m3. 3, the I20 steel body weight: 0.28 KN/m; 4, I36 steel body weight: 0.66 KN/m; Belay retakes 1KN/m (including connectors and other appendages); 6, the concrete self-retakes 20KN The combination of load and load According to the design criterion of building load, the design value of uniform load is equal to the coefficient of structural importance. The coefficient of constant load is 1.2. To load analysis 320 cm Concrete tank car for three axis, considering weight is 550 kn, according to the center of gravity of the vehicle, the front wheel axle load of 110 kn, two rear axle is 220 kn rear axle spacing is 1.3 meters, wheel spacing is 1.9 meters. 130 cm160 cm 30 cm 30 cm Figure 1 Figure 2 The verification of the component parts (1) the deck check calculation The bridge of piers is placed directly on the I20 steel, which is 1 meter apart, and is calculated by the width of the unit length (2.4 meters). Suppose a rear axis ACTS on the co