2011年过程设备设计复习题及答案(国外英文资料).docVIP

2011年过程设备设计复习题及答案(国外英文资料) Process equipment design review problem and answer A, single topic selection Storage devices 5.1 double saddle support design horizontal storage tanks, the state of the two bearing should be adopted: (C) a. both fixed b. both portable c. A fixed, A mobile d. above all can The pillar of A low temperature can be used in conjunction with the shell (C) A. B. the structure of the Plato board? C.u-shaped column structure?? The strut of D 5.3 horizontal tank saddle occur: (A) is the root cause of a. joints of cross section subjected to shear and circumferential bending moment b. cylinder is not set stiffening ring c. pedestal setting position is not suitable for d. design pressure is too high With the development of the oil industry, the most commonly used combination of tanks on large canisters is: (C) a. pure orange peels B. football, flapper, c. mixed tank d. two hemispheres Heat exchange equipment 6.1 points, according to the structure of the following does not belong to the tube and shell heat exchanger (B) a. b. fixed tube-sheet heat exchanger heat exchanger c. D.U form of floating head heat exchanger tube heat exchanger 6.2 common tube and shell heat exchanger and plate heat exchanger are the following: (C) what type of heat exchanger a. b. direct contact heat exchanger heat exchanger c. d. recuperative heat exchanger heat transfer style heat exchanger in the middle 6.3 the following type does not use the tube side and shell side of heat exchanger heat transfer: (B) a. coil heat exchanger b. c. of casing heat exchanger tube and shell heat exchanger d. coil tube heat exchanger In the following description of tube heat exchanger, the mistake is (C) A.Tube heat exchanger is still an absolute advantage in high temperature, high pressure and large heat exchanger, it is the most widely used type heat exchanger. The tube heat exchanger is a type of tube heat exchanger, which is made of metal or non-metallic tubes and bent into the desired shape. C